3
STEP 3
Fasten the straps to secure the frame.
STEP 4
Place the plastic mounting clips
(D)
in the center
of each exposed portion of the steel bars.
NOTE:
Make sure the wire management flap on
the panel
(A)
is facing the inside of the desktop.
STEP 6
Mark the locations of the mounting clips
(D)
using a pencil. Drill pilot holes using a 1/8”
(3mm) bit and mount the assembled panel to the underside of the desk using the 7/8”
screws
(C)
as shown.
STEP 7
Route and organize the cables and secure
them using the flap on the panel
(A)
.
STEP 5
Center the assembled panel under the desktop.
D
C
NOTE:
Desktop must be
at least 1” thick to prevent
screws from poking out
through the top
and damaging the surface.
