2
Height Adjustment:
Press and hold the up or down arrow until the desk reaches the desired height. Press
and release the arrow quickly for minor adjustments.
Timer:
To set the timer, press “T”. The display will flash “0.5h” representing 30 minutes. Press “T” repeatedly
to increase 0.5 hours at a time. The maximum timer setting is 2 hours. The timer is set when the display stops
flashing and the light in the top right corner of the controller is on. When the timer has reached the set time,
a beep will sound reminding the user to adjust the working position. Once the timer setting has expired (5
beeps), the unit’s timer is canceled. To deactivate the timer, press “T” five times or until the current height is
displayed and the light in the upper right corner is turned off.
Memory Setting:
To store a certain height in the controller’s memory, first press “M”. The letter “S-” will be
displayed. Now press “1”, “2” or “3” within five seconds to store the current height in memory. Each number
can store a different height. Once in memory, you can recall any of the three height settings by pressing the
corresponding button. Touching any button (except for “T”) will stop the automatic adjustment .
Changing between CM and INCH:
The preset measurement shown on the display is cm. If you would like to
change cm to inch, then press "T" for at least 3 seconds. The controller will beep twice when changed to inch.
Repeat to switch back from inch to cm, and the controller will beep once.
Reset Mode:
Press and hold the up and down arrows together until the desk beeps and moves to the fully
lowered position (do not release until the process is complete).
Sleep Mode:
After resting for 10 minutes, the screen will turn off to prevent accidental operation. Touch the
screen to exit sleep mode and operate the desk.
Memory
Indicator
light
E12/E13 Troubleshooting
The system has experienced unusual electrical problems.
Disconnect the power first, then wait for 30 seconds (until
the display stays off) and reconnect.
E02 HOT Troubleshooting
The system is overheating. Allow your desk to cool down
and remain idle for approximately 18 minutes.
