3
STEP 2
STEP 3
Position the base clip on the adapter bracket
(A)
and insert the screw from step 1 or the M6x20
bolt
(G)
into the center hole in the bottom of bracket. Tighten securely. If needed, use the included
washers
(C)
to enable a more secure fit. Depending on what size is required, install the self-tapping
screws
(D, E or F)
with washers
(H or I)
into the side holes in the bottom of the bracket.
Connect the VESA plate to the adapter bracket
(A)
using four M4x12 thumb bolts
(B)
. Partially insert
M4x100 bolts
(J)
into top two unused holes of the VESA plate and adapter. Place pads
(K)
on the ends
of the screws, and tighten until pads press lightly against the monitor.
