3
ASSEMBLY STEPS
STEP 1
TOOLS NEEDED
Phillips
Screwdriver
OPTION A: Clamp Installation
Loosen clamp bolts in clamp
(L)
using 6mm Allen wrench
(B1)
. Slide decorative cover
(K)
onto pole
(B)
. Attach pole to clamp using flat head bolts
(T)
and tighten with 4mm Allen wrench
(A1)
, then slide
decorative cover down onto clamp. Apply protective pad
(M)
to bottom of clamp base. Place support
plate
(J)
onto clamp bolts, place clamp with pole onto desk, and tighten clamp bolts evenly using
6mm Allen wrench. Attach cable management clip
(R)
to pole. If needed, change clamp height by
removing bolts from the back of the clamp, then reattach at alternate height.
OPTION B: Grommet Installation
Attach grommet base
(N)
to pole
(B)
using flat
head bolts
(T)
and tighten with 4mm Allen wrench
(A1)
. Cut end from protective pad
(M)
, and apply
remaining circular pad to bottom of grommet
base. Remove one bolt from the clamp
(L)
, then
use bolt with support plate
(J)
to secure base
with pole to desktop and tighten with 6mm Allen
wrench
(B1)
. Attach cable management clip
(R)
to pole.
17.6 lbs
(8 kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
4.4 lbs
(2 kg)
MOUNT
TRAY
M
T
A1
K
B
B1
L
J
20-88m
m
B1
R
A1
J
A1
10
-50
mm
1
2
3
M
B1
0mm-
55
mm
R
J
B1
A1
T
N
