Vivo STAND-SIT1W, Instruction Manual

3

ASSEMBLY STEPS

OPTION A: Wood Stud Mounting

Hold arm 

(A)

 to wall where stud is located and mark top 

hole location with a pencil.  Drill 2.2” (55mm) deep hole 

using a 3/16” (4.5mm) drill bit, and insert screw

 (W-A)

leaving 6mm of thread exposed.  Hang arm on screw, 

and making sure arm is level, mark 2 additional drilling 

locations using the vertically aligned holes. Drill holes, 

then mount arm using screws

 (W-A) 

with washers

 (W-C)

.

STEP 1

OPTION B: Concrete/Brick Mounting

Hold arm 

(A)

 to wall where desired and 

mark top hole location with a pencil.  

Drill 2.4” (60mm) deep hole using a 3/8” 

(10mm) drill bit, and insert anchor 

(W-B)

.  

Insert screw 

(W-A)

 leaving 6mm of thread 

exposed.  Hang arm on screw, and making 

sure arm is level, mark 3 additional drilling 

locations.  Drill holes, insert anchors

 (W-B)

, 

then mount arm using screws 

(W-A) 

with 

washers 

(W-C)

.

6mm

W-B

W-C

W-A

TOOLS NEEDED

Phillips 

Screwdriver

Drill

Pencil

STEP 2

Slide decorative covers 

(D) 

on 

arm

 (A)

.

STEP 3

Remove knob and slide VESA 

plate off from bracket. Set parts 

aside for later use.

STEP 4

Remove two lower screws from 

back of pole 

(B)

 and set aside.  

Attach tray 

(C) 

to pole using 

M8x24 bolts 

(E)

, and tighten 

with 6mm Allen wrench 

(G)

. 

D

G

F

E