3
ASSEMBLY STEPS
STEP 1
Press the lock on each caster
(B)
to the down (locked) position, then install the casters to the base
(A)
.
Adjust to sit flat if needed, then tighten each caster using the 10mm wrench
(U)
.
TOOLS NEEDED
Phillips
Screwdriver
Wrench
STEP 2
Slide the base poles
(C)
into the base, making
sure the cable holes are facing towards the
back, then secure the poles using x4 M8x20
bolts
(M)
. Turn the bolts using the 5mm Allen
wrench
(W)
, but do not yet tighten.
Needle Nose
Pliers
STEP 3
Slide the shelf mounting brackets
(F)
onto
the base poles. Insert the upper poles
(D)
into the base poles, making sure the cable
holes are facing in towards the center, then
secure the poles using x8 M6x8 bolts
(N)
.
Tighten with the 4mm Allen wrench
(V)
.