6
Insert x2 M8x20 bolts
(M)
into either the front or rear lower holes of the mounting plate. Tighten all
bolts with the 5mm Allen wrench
(W)
.
STEP 8
To adjust the ease of
rotation, loosen or tighten
the nuts on the back of the
mounting plate using the
6mm wrench
(T)
.
STEP 9
To lock the position, insert the M6x18 bolt
(P)
into the back of the mounting plate using a
Phillips screwdriver. Use the side hole for portrait, or the top hole for landscape.
STEP 10
Route cables through the cable holes in the poles and the openings in the front cover and mounting
plate. Stick adhesive cable tie holders
(R)
onto the back of the mounting plate in the positions shown.
Pull excess cable up into the mounting plate area, making sure there’s enough slack for free rotation of
the TV if needed, and secure to the tie holders on the side using cable ties
(S)
.
STEP 11
