2
3
ASSEMBLY STEPS
STEP 1
Option A: Desk Clamp Install
Install the pole
(A)
to the weighted base
(B)
using 3 M5x14 bolts
(E)
. See Figure 1.
PACKAGE CONTENTS
TOOLS NEEDED
WARNING!
Phillips
Screwdriver
A
(x1)
Pole
B
(x1)
Base
C
(x1)
Swivel Arm
N
(x1)
Wrench
O
(x8)
M4x12 Thumb
Bolt
R
(x1)
Soft Pad
M
(x1)
Allen
Wrench Set
J
(x1)
Spring Washer
K
(x1)
Grommet
Base Plate
L1
(x1)
Wire Clip
L2
(x4)
Wire Clip
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE:
SOME HARDWARE INCLUDED MAY NOT BE USED
D
(x2)
VESA Plate
E
(x3)
M5x14 Bolt
F
(x2)
Nut
G
(x1)
M10 Bolt
H
(x1)
Support Plate
I
(x1)
M10 Washer
Q
(x8)
M4 Spacer
P
(x8)
M4x30 Bolt
Option B: Grommet Base Install with Existing Hole
If you prefer grommet base installation, but no
grommet hole is present, drill a 3/8 (10mm) hole
through the mounting surface and proceed with
Option B.
1.
Install grommet base plate (
K
) to the pole (
A
)
using 3 M5x14 bolts (
E
). See Figure 3.
2.
Attach soft pad (
R
) to the grommet base plate (
K
)
, see Figure 4.
3.
Position pole (
A
) on the mounting surface and
secure using the support plate (
H
), M10 washer
(
I
), spring washer (
J
) and M10 bolt (
G
). Fasten
M10 bolt using provided wrench (
N
). See Figure 5.
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
•
NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR
STAND.
•
USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
a
e
b
Figure 1
h
g
i
l
j
Figure 2
a
k
e
Figure 3
r
Figure 4
h
g
i
j
Figure 5
OPTIONAL:
For more secure
mounting, you can drill a 10mm
diameter hole in your desk and
secure using the support plate
(H)
,
M10 washer
(I)
, spring washer
(J)
and M10 bolt
(G)
. Fasten the M10
bolt with provided wrench
(N)
, see
Figure 2.
22 lbs
Per Arm
(10kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
