4
5
STEP 2
Install swivel arm
(C)
to the pole
(A)
. Fasten the bolt with supplied allen wrench
(M)
. Attach the wire
clips
(L1, L2)
to the pole
(A)
and swivel arm
(C)
.
STEP 3
STEP 4
STEP 1 (Continued)
Option C: Grommet Base with Self-Drilled Hole
1.
Position the Pole
(A)
on the mounting surface
and mark the center hole. Drill a 3/8” (10mm)
diameter hole at the marked position
through the mounting surface.
2.
Install the Grommet Base Plate
(K)
to the
Pole
(A)
using M5x14 Bolts
(E)
, and tighten
using the Allen Wrench (
M
), see Figure 6.
3.
Attach Soft Pad
(R)
to the Grommet Base
Plate
(K)
, see Figure 7.
4.
Position the Pole
(A)
on the mounting surface
and secure using Support Plate
(H)
, M10
Washer
(I)
, Spring Washer
(J)
, and M10 Bolt
(G)
. Fasten the M10 Bolt using provided
Wrench
(N)
, see Figure 8.
k
a
e
Figure 6
r
Figure 7
h
g
i
j
Figure 8
c
m
l1
l2
OPTION A: Flat Back Monitor
Attach the VESA plate (
D
) to the monitor using
M4x12 thumb bolts
(O)
.
NOTE
: Hand tighten screws to avoid over
tightening.
OPTION B: Curved Back Monitor
Attach the VESA plate (
D
) to the monitor using M4
spacers
(Q)
and M4x30 bolts
(P)
.
NOTE
: Hand tighten screws to avoid over
tightening.
o
q
p
Slide the monitor onto the head of swivel arm (
C
). Install the security nut
(F)
. Make sure the security
nut is installed before you rotate the monitor.
f
