VXS-1488AR
INSTALLATION GUIDE
PAGE 2 of 2
ELECTRICAL CONNECTIONS
WARNING
: Before starting with any electrical connections make sure the supply wires are not energized.
Connect the
RED
wire of the siren to the
PHASE
lead of your 110-120V AC power source.
Connect the
WHITE
wire of the siren to the
NEUTRAL
lead.
IMPORTANT
: The connections of the red and white wires can be switched, red wire can be connected to
neutral lead and white wire to phase lead.
Unscrew the small screw located in the siren's body to connect the
GROUND
lead and tighten the screw.
To activate the siren manually your power source must have a switch installed.
If the siren is being used as part of a smoke detector, gas sensor, timer or anti-theft alarm system, please
follow your device’s instruction.
MAINTENANCE
Other than cleaning, no maintenance is required.
To ensure the siren is operating properly, it should be tested frequently.
