VXS7910
INSTALLATION GUIDE
PAGE 2 of 2
ELECTRICAL CONNECTIONS
SPEAKER CABLE (GREEN)
: Route both cables through the fire wall of your vehicle to attach it to the
speaker previously installed in the engine compartment.
MICROPHONE (MIC)
: To use the unit as a PA system, connect the microphone's cable plug to the control
box.
POWER CABLE (RED/BLACK)
: Connect the positive wire (Red) to a power source in the vehicle that only
gets power when the vehicle’s ignition is on. Recommended connection points are: windshield wiper motor,
blower motor or an accessory terminal on the fuse panel. Use a 5A fuse (not provided) on this connection for
circuit’s protection. Connect the negative wire (Black) to ground, any rust and paint free metal body bolt or the
negative (-) battery post.
OPERATION
To start using the electronic horn set the vehicle's ignition to the ON position.
OFF
: Turning the KNOB clockwise will increase the volume, while moving it counter clockwise will decrease it.
MODES
:
o
WAIL-2
:
Press this button to produce a “Wailing” sound.
o
WAIL-1
:
Press this button to produce a “Wailing” sound.
o
HI-LO
: Press this button to produce a two-
tone “HI-LO” sound.
o
HORN
:
Press this button to produce a “Horn” sound.
o
SIREN
:
Press this button to produce a “Siren” sound.
o
MIC
: Make sure the microphone cable is connected to the control box, pressing the button located on
the left side of the microphone will start broadcasting your voice, release the button to stop
broadcasting.
