www.vizi-tec.com
November 26, 2017
Page 15 of 24
Contact
Typical Universal Installation(OEM connector not included):
(Please verify that your vehicle’s brake light is working before proceeding with this modification)
1.
Turn off vehicle. Using included Posi-Lock connectors. Tap into the (-)Return wire of the vehicle’s third brake light.
2.
Cut and splice open the (+)Hot/Signal wire of the vehicle’s third brake light.
a.
Connect the source side with red wire from SBT-4K
3.
Connect the load(brake light) side with white wire of SBT-4K..
4.
Turn on vehicle and test. Done!
To
Third
Brake
Light
(load)
SBT
Return
Input Brake Signal
Output Modulated Brake Signal
From Brake
switch/peddle of
car
Posi-Locks (3x)