ENG - 7
After turning on both your TV and sound bar, it will automatically begin searching for an active input.
*
The LED indicator on the front of the sound bar will begin cycling in different colors through inputs
until an audio source is detected.
**
You can press the INPUT button to switch between audio
sources. For example, if you connected your TV to HDMI
(ARC), set the sound bar to HDMI-ARC.
3
Remove the battery cover by gently
sliding it away from the remote.
4
Insert the included batteries and gently
slide the battery cover back into place.
5
Top
Top
*Occurs only during first-time set up.
**Auto detect function only occurs once when the sound bar is first powered on. To enable this
feature again, you must do a Factory Reset (see the Using Button Combinations on page 12 for
more information) or press and hold the INPUT button for 4 seconds
.
When needed, VIZIO recommends replacing the batteries that came with
this remote with two, new Duracell ‘AAA’ alkaline batteries.
First-time Setup
Tip: Pressing the INPUT button will stop the auto
detect function.
Input
Power
Summary of Contents for V 2.0 Series
Page 2: ...ENG ii Acc Con Ema Pho Bindi This p Class By us You ha days o Terms ...
Page 34: ...ENG 28 ...
Page 35: ...ENG 29 ...
