VIZIO Universal Remote Control User Guide
Version 8/6/2004
13
Chapter 4 - Troubleshooting
4.1 - Common Concerns
Use the following information to solve common issues.
Problem:
The LED doesn’t blink when a button is pressed.
Solution:
Replace the batteries. See “Insertion of Batteries in the Remote
Control” on page 6.
Problem:
The LED blinks when a component mode is pressed, but the
component does not respond.
Solution:
Make sure that you are less than 15 feet (4.57 meters) from the
infrared remote sensors on the component.
Make sure that nothing is blocking the infrared remote sensors on
the remote control or the component.
Make sure that you have selected the correct component mode.
Make sure that the remote is programmed for that component.
See “Programming the VIZIO Universal Remote Control” on page
8.
Problem:
The remote control will not accept the component program code.
Solution:
Make sure that you followed all the steps in the programming
procedure. See “Programming the VIZIO Universal Remote
Control” on page 8.
Make sure that you tried all the program codes listed for the
component manufacturer. See “Component Program Codes” In
Appendix B.
Search for the component code. See “Searching for Component
Codes” on page 11.
