UF-216 water Filtration system
7
A.J. Antunes & Co.
P/N 1011078 Rev. B 03/12
OVerVIew
Overview
The UF-216 system operates in two modes:
• Normal Operation Mode
• Flush Mode
During Normal Operation Mode, water enters the Inlet
and flows through the Ultra Filter before exiting the
Permeate Outlet as usable product water.
During Flush Mode, the Drain Valve opens and water
entering the Inlet flushes and cleans the Ultra Filter
membrane by removing any debris collecting on the
membrane wall.
The Drain Valve is only powered during Flush Mode.
nOte: Do nOt unplug the power cord or turn off
the system during flush mode. If there is a power
outage or the system is unplugged, water will con-
tinue to be filtered but the system will nOt flush.
this could cause the ultra filter to plug premature-
ly and may void the warranty.
The flush is automated by the controller to last 10
seconds and take place in one hour intervals. This
interval can be changed (see
Changing the interval
setting
in the Maintenance section of this manual).
manual flushing
A manual flush can be activated at any time by pressing
the
flusH
button.
When the
flusH
button is pressed, the Flush leD on
the controller flashes and the Drain Valve opens for 10
seconds. After flushing is complete, the Drain Valve will
close, the Flush leD will stop flashing and the unit will
automatically return to Normal Operation Mode.
nOte: a manual flush will not affect the interval
flush setting.
cautIOn
changing the flush interval can cause the ultra
filter to plug prematurely and may void the war-
ranty. consult the factory for more information.
figure 2. uf-216 system
