Eccellenza Pod
Replacing Components
53
Powder Dispenser and Waste Bin Detection Switches
Three detection switches are used in this machine – one to detect the presence of the
waste bin, and the other two to detect the presence of the powder dispensers.
Should you need to replace any one of these detection switches:
1.
Remove the waste bin, the two powder dispensers, the top panel and the rear panel.
2.
Disconnect the wiring connector at the rear of the switch that is to be replaced.
3.
Compress the clip at the front of the switch to unlock it and remove the switch.
4.
Press the new switch into the cutout in the metal until the clip locks it in place.
5.
Connect the wiring connector to the rear of the switch.
6.
Re-install all of the panels, the powder dispensers and the waste bin and test the
machine to make certain everything is functioning properly.