10
GRAPHITE 2
.
Assembling gide
Make the needful size hole in the fuselage to mount the tow hook (as shown at the picture 18). For better
adhesiveness sand the inner part of the fuselage by the sanded paper in the gluing spot.
Glue in the tow hook unit with the epoxy.
After the epoxy polymerization cut the part of the tow hook unit flush with fuselage.
Screw the tow hook.
pic. 19
Sand the tongue gluing spots inside the fuselage by the sanded paper. Paste the epoxy on to the tongue in
the spots shown with arrow at the picture 19 and 23, and glue it into the fuselage.
Wipe out the extra epoxy. Check the tongue gluing depth by putting the nose cone on. Put off the nose
cone and check if the tongue and fuselage gluing axis coincide. Wipe the extra epoxy. Fix the tongue with
the glue tape untill the epoxy polymerization.
pic. 20
Make a hole in the fuselage to glue the pushrods pipes as shown at the picture.
Glue the pushrod tip to one side of each rod and screw the ball tips on.
Fix the pipes together in two spots by the glue tape. Put the rods into the pipes and then put them into the
fuselage. The pipes are to end at the same point where the stabilizer joiner is. Press the pipes to the lower
part of the fuselage and glue them by the cyanoacrylate adhesive through the hole in the fuselage.
