11
GRAPHITE 2
.
Assembling gide
Watch carefully to prevent the glue getting inside of the pipe and fixing the rod. For this put the fuselage
vertically tail up.
pic. 21
Mount the stabilizer and put the ball rod tips to the horns. Use special instruments to put the ball stabilizer
tips on to the horns. You should put the rod out of the fuselage and fix it with some pin (e.g. small screw
driver) before putting the horn into the rod tip (as shown at the picture).
pic. 22
Pull the pipe in the servo horn direction and glue it to the ballast mounting tube through the hole at the
place of wing fixing.
Cut the rods so that after putting on the tips with the screwed on plugs you could get approximately
neutral position of the elevators when the servo horns also have neutral position. Then glue the tips to the
rods.
Watch carefully to prevent the glue getting inside of the pipe and fixing the rod.
