12
GRAPHITE 2
.
Assembling gide
Make several wooden supports for the pipes and fix them as close to the servos as possible. Regulate the
length of the rods by screwing the plugs onto them to get the coincidence of the neutral position of the
servo horns and the elevators.
Warning!
As carbon is used for the fuselage the receiving antenna is to stand out of the fuselage
as close to the receiver as possible. You should fix it to outside the fuselage by the glue
tape and pull its end to the V-form tail.
Pay attention to this warning!
4. Model gravity center regulation
The center of gravity of the model is to be situated 110mm back from the wing front edge. Choose the
needful weight ballast and glue it in the front part of the tongue.
pic. 23
You can regulate the center of gravity more carefully during the flight according to your flying style.
5. RECOMMENDED DEVIATION OF THE CONTOROLLING
SURFACES FROM NEUTRAL
Ai12-17 mm / -5-10 mm
El12 mm / -12 mm
10 mm / -10 mm
Take off mode (glider version)
Ailerons downwards 5 mm
Flaps downwards 5 mm
Elevator upwards 1mm*
*
Regulate to the maximum though the machine shouldn't "dance" at the start
