24. Pull the inner chimney shaft right up and secure it using the two 10 mm self-
tapping screws in the side of the mounting bracket. (Fig. g)
18. Full the inner chimney shaft straight upwards to the ceiling and press it firmly
against the wall.
20. Slide the inner chimney shaft slightly downwards.
21. Hold mounting bracket 3 (Fig. e) for the inner (upper) chimney shaft centrally
between the pencil marks right up against the ceiling and mark the 2 drill holes
through the bores in the mounting bracket.
22. Remove the mounting bracket again and then use an 8 mm masonry drill to
make 30 mm holes in the 2 drill holes marked on the wall for the mounting bracket.
23. Insert 2 wall plugs in the drill holes you have made, then secure mounting
bracket 3 (Fig. e) with two 30 mm screws.
19. Mark out a short line right at the top of the wall, on both sides of the inner
chimney shaft. (Fig. f)
25. Lift up the front section of the hood, remove the grease filter and secure the
hood using two 30 mm screws through the 2 holes in the back of the hood. (Fig. h)
26. Fit the carbon filter to the side of the motor. (see User's Manual chapter
"Installation of the carbon filter"
16. Slide the inner (upper) chimney shaft fully into the outer (lower) chimney shaft.
17. Place the interlinked chimney shafts onto the hood and hook this structure onto
mounting bracket 2 (Fig. e).
1
2
3
Fig. e)
Fig. f)
Fig. g)
Fig. h)
fi190920TNM
3
/
4