4
5
Installation
Getting Started
Installation
• In-wall installation should be located directly above the
listening area. In rooms larger than the bathroom or
closet, it is recommended to install additional speakers for
improved performance.
• You may install a bracket where you will be placing the
speaker prior to installing drywall. Once insulation and
drywall is installed, you may cut the speaker hole.
• Use a stud-finder to locate the nearest wood or metal
stud and keep in mind the baffle flange will protrude
outside of the mounting hole.
Painting The Wall Speakers
• It is recommended to paint your speaker before installing
into your wall, or reverse the steps of installation to
remove the speaker for easy painting. For painting the
installed speaker, please use the paint mask in place of the
grille. If painting the grille, do not paint while attached to
the speaker, and be careful to not clog the holes, which will
decrease sound quality. VM Audio recommends only light
spray painting.
• When running long lengths of speaker wires, it is
recommended that higher gauge wire (14 Ga or higher) is
always used throughout the wiring.
• For non-distorted high output performance, use an
amplifier with the same power rating as the loudspeaker.
Power Requirements
Speaker Wires
1. Choose a location in your
home to setup your new VM
Audio in-wall speakers.
2. Using the included template,
position and outline the hole
on the wall.
3. Cut the drawn hole
using a drywall saw.
