CBF 125 AIR COOLING ENGINE SERVICE MANUAL
XTREET 125 EFI
10
- 10 -
2.5.
Valve Clearance Adjustment
Too large valve clearance will result in noise and
ultimately in damage of engine. Too small valve
clearance or no clearance will result in that valves are
not closed tightly, thus causing valve damage and
power loss of the engine.
Remove caps with big and small view hole,
respectively, from engine.
Turn crankshaft until the engine is at timing position
(Mark line “T” on rotor of magneto is aligned with
center of view hole.)
Remove upper cover of cylinder head
(refer to 4.2 section)
Check Valve Clearance
Note:
The inspection and adjustment of the valve
clearance shall be checked and adjusted under
the “cold machine” condition of the engine.
Clearance
will
change
as
the
engine
temperature rises.
Adjust Valve Clearance
Inlet and exhaust valve clearance: (0.04-0.06) mm
Tightening torque of adjusting nut: 14N.m
Inspect for distortion or damage at the O-ring View
hole cover, if exist any, the O-ring needs to be
replaced; after the new O-ring is replaced, apply a
proper amount of lubricant on the new O-ring before
assembling.
Summary of Contents for CBF 125
