VMAC
– Vehicle Mounted Air Compressors
VMAC Technical Support:
1-888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
30
Recommended Accessories
While the compressor system will function without the following accessories,
VMAC strongly recommends their use for optimal performance.
Receiver Tank
A receiver tank reduces the duty cycle of the compressor, and can help the
Gas Engine Driven 30 CFM Air Compressor run tools with higher cfm
requirements. It can also provide a buffer so that tools can be used
immediately upon system start up.
For information on installing an air receiver tank see the
“Air Receiver Tank”
section of this manual on page 31.
Air receiver tanks are available for purchase through VMAC. See the
“Accessory Product” section of this manual on page 34 for more information.
Pressure Gauge
While not critical to system performance, a pressure gauge is important for
fine tuning the system and simplifies any potential troubleshooting.
Install a 200 psi pressure gauge downstream of the air discharge valve.
Pressure Regulator and/or Lubricator or FRL
The compressor can produce air pressures up to approximately 150 psi
(1035 kPa). It is the responsibility of the user to know the pressure and air flow
requirements of the tools powered by the air compressor system.
An appropriate air pressure regulator and lubricator can be installed
downstream of the air discharge valve. Failure to regulate the air pressure may
cause damage to the tool.
FRL’s are available for purchase through VMAC. See the “Accessory
Product
” section of this manual on page 34 for more information.
Summary of Contents for G300003
