VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
24
Mounting without the base plate
The Gas Drive engine and WHASP tank can be mounted in separate
locations if removed from the stand-alone base plate.
Locate a suitable mounting position for the Gas Drive engine and
WHASP tank. Place the components and check for clearances to
any other objects.
There are four holes on the base of the engine, use the most-outer
holes for mounting (two at the front, and two slotted) (Figure 13).
There are 4 outer bolt holes on the WHASP tank which can be used
as mounting bolt locations (Figure 13).
Drill 4 holes in mounting surface and secure the Gas Drive engine
and WHASP tank to the vehicle. Use bolts, washers and locknuts or
Loctite.
Remove the #8 cap from the air outlet, found near the pressure
relief valve on the WHASP tank, to the right of the battery. Connect
to the air delivery.
All dimensions are in inches.
Figure 13 - Mounting without baseplate (dimensions in inches)
If the Gas Drive is not mounted on the stand alone base
plate and the WHASP tank is relocated to another
location, ensure that the hose lengths will be the shortest
possible and a minimum number of 90 degree fittings will
be used, this will ensure optimal performance. See the
hose requirements on the following page.
3.7
7.7
6.75
9.0
Summary of Contents for RAPTAIR-G30
