VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-800-738-8622 Local: 1-250-740-3200
Fax: 1-250-740-3201
19
4.0
Electrical Connections
There are five main electrical connections to the RAPTAIR MF:
▪
Display Panel Assembly - Key Switch, Display Box and
PTO/GENSET/COMPRESSOR ON/OFF Switches
▪
Remote Start Wire
▪
Welder Control Panel
▪
(optional) Cold Climate kit
– 110VAC Cold Climate Kit
Heater Connection
4.1
LED Beacon Connection
The 2 LED beacons will illuminate in STANDBY mode
to inform the operator that the RAPTAIR MF is able to
restart when air-use is detected.
4.2
Display Panel Assembly Connections
To fully utilize the features of the RAPTAIR MF, the display panel
with the key switch and display box should be mounted in a
convenient location for the operator.
Mount the Display Panel inside the cab or a cabinet
protected from extreme weather. The Display box is
splash-proof, but not fully sealed. Ensure that it will not
get kicked or hit by tools and equipment.
There are separate connectors for the Display box cable and the key
switch
in the same location as the “Air Discharge Port”. Pigtails have
been provided with blunt cut wires for installer connection at the
RAPTAIR MF and the Display Panel. The table below has
recommended wire sizes for a typical installation. The size may
need to be increased for long distance routings between the two
components to avoid excessive voltage drops.
Summary of Contents for RAPTAIR-MF D600007
