VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-800-738-8622 Local: 1-250-740-3200
Fax: 1-250-740-3201
33
7.4.3
System Running Menu
If any messages are present, the WARNING LED
will flash on & off, the READY LED will remain on,
and the messages will cycle on the display.
If no messages are present, the display will cycle through the
SYSTEM RUNNING*, AIR PRESSURE, and TIME TO UNLOAD (*
or current control state see Control System Operation).
Pressing the NEXT or BACK buttons in SYSTEM RUNNING menu
will take the user to the additional information menu where specific
information about the RAPTAIR MF sensors are displayed.
Pressing the ENTER or EXIT button will initiate the stopping
sequence.
7.4.4
Stopping Sequence
To stop the RAPTAIR MF unit as detailed in section 7.3.2 the user
can press the ENTER button at any point during operation, in
addition,the user may also turn the key switch from the RUN position
to the OFF position.
7.4.5
Additional Information Menu
The additional information menu for the display box allows the user
to monitor specific information about the RAPTAIR MF unit. The
parameters displayed are: air pressure, air rate, engine speed,
engine temperature, compressor temperature, time to unload (or
standby), and hour meter.
The user can scroll through the screens by pressing the BACK and
NEXT buttons.
Pressing the EXIT button will return the display box to SYSTEM
RUNNING menu.
The display box will return to the SYSTEM RUNNING
menu after three minutes of no buttons being pressed by
default.
Pressing the ENTER button will initiate the stopping sequence (see
Control System Operation)
Summary of Contents for RAPTAIR-MF D600007
