VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
30
☐
Connect the 1/4 in PTFE tube into the push-to-connect fitting installed in the
WHASP Tank (Figure 32).
☐
Route the 1/4 in PTFE tube to the bulkhead fitting, ensuring the tube will not
kink, and cut the hose to length.
☐
Install the tube into the push-to-connect bulkhead fitting (Figure 33)
☐
Secure the tube with the supplied cable ties.
Ensure the tube is cut square and that there are no sharp edges. Do
not use side cutters as this will deform the hose.
Figure 33 — Tubing Installation Remote Blowdown Muffler assembly
Figure 32 — Tubing Installation
Install PTFE
tube