VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
20
☐
From the OEM quick connector cuff on the engine side of the hose, measure
6 in along the outside radius towards the center of the hose and mark with a
grease pen (Figure 18).
Figure 18 — Lower radiator hose modification
90°
6 in
To engine
☐
Cut the radiator hose in the two marked locations, ensuring that cuts are
square to the hose section.
☐
Install the modified radiator side of the lower radiator hose onto the radiator.
☐
Install the modified engine side of the lower radiator hose onto the engine.
☐
Remove the anti-abrasion sleeve from the center section of the lower radiator
hose and slide it over the radiator side coolant tube; securing it in place with
cable ties (Figure 19).
Figure 19 — Radiator side anti-abrasion sleeve
(Coolant assembly removed from vehicle for clarity)
Mesh abrasion
sleeve