VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
32
☐
From the OEM notch on the top right of the stator, count clockwise (×6) vanes
and mark the outer edge, tracing the profile of the cowl (Figure 41).
☐
Using a die grinder or similar tool, cut the hard plastic lip flush with the cowl of
the stator (Figure 41).
☐
Cut a rectangle out of the soft rubber section on the back of the fan shroud
Figure 41 — Stator modifications
Figure 42 — Fan shroud modification
1/2 in
8 in
