VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
81
Figure 124 — Modified degas hose network
☐
Using the hose that previously ran to the OEM degas location, connect the
degas bottle to the spigot marked “DGAS” (Figure 124).
Figure 125 — Connecting the positive battery cables
☐
Secure all of the connections with hose clamps.
☐
Reinstall the lower bumper air dam.
☐
Fill both coolant reservoirs with the coolant saved earlier.
☐
Confirm that all OEM hoses and wires that were shifted during install are
secured away from any hot, sharp or moving parts.
☐
Confirm that all VMAC hoses and wires are secured as necessary with cables
ties and/or rubber P-clips to prevent contact with any hot, sharp, or moving
parts.
☐
Remove the protective tape from the ring terminal on the front battery’s
positive cable and insert it into the red cable connection boot (Figure 125).
