VMAC
–
Vehicle Mounted Air Compressors
Toll Free:
1-800-738-8622 Local: 1-250-740-3200
Fax: 1-250-740-3201
33
8.
Remove and discard the O-ring seal and the rear cap seal.
9.
Wipe out the inside of the tank
10. Remove the thimble screen and spring and clean the discharge
cap.
If you use solvents for cleaning, thoroughly rinse the
parts with hot water to remove all solvent residues.
11. Clean the thimble screen spring and clean or replace the thimble
screen.
12. Install a new O-ring and rear cap seal.
13. Thoroughly clean the large spring and spring plate. Remove any
rust or contaminants.
14. Install the large spring or wave spring (with spring plate on 150
systems
– tapered end away from the filter) and a new
coalescing filter. Make sure that the spring is in place, as it holds
the coalescing filter tight against the rear cap seal.
The large spring or wave spring also prevents
electrostatic buildup by grounding the coalescing
filter. If the spring is not installed, an electric arc may
occur, which could result in an explosion, potential
tank rupture or fire.
15. Install the discharge cap and torque the bolts to specifications.
16. Install the lines on the back of the tank.
17. Remove the filler plug from the air inlet control valve.
18. Pour compressor oil into the oil filler hole on the inlet control
valve using a funnel.
You must use the supplied compressor oil in this
system. Failure to use this special oil will result in
damage to the compressor and may void your warranty.
19. Turn the compressor clutch clockwise to speed the fill process.
Summary of Contents for VR150
