VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
68
□
Do not use any air and wait until system enters STANDBY. (By
default, this Delay to Standby is 10 minutes)
□
Truck engine should turn off.
□
Check the LED Beacon gives four quick flashes then a pause.
This should repeat once every second.
□
Operate the system with an air tool or with the test tool to drop
the air pressure below the RESTART PRESSURE setting. (By
default, this is 120 PSI)
□
The control system should sound the Buzzer and turn off the
Beacon.
□
Now the system should crank and start the engine. Wait for the
engine to settle to VR-IDLE RPM.
□
Place your foot firmly on the brake pedal, shift the automatic
transmission out of PARK and into REVERSE. The engine
should drop to OEM base idle (about 650 RPM). Repeat this test
in all gear selector positions to make sure that the engine does
not idle up unless the selector is in PARK.
□
Place the transmission into PARK.
□
Operate the system with an air tool or with the test tool for at
least 1/2 hour (1 hour preferred).
□
Road test the vehicle for approximately 14 miles (20 km).
□
Inspect the underhood operation to make sure that belts rotate
properly and nothing is rubbing or contacting hot parts.
□
Check all components once the engine is turned off and the
system has cooled.
□
Check the vehicle coolant after the vehicle reaches operating
temperature.
□
Check the compressor oil level after the vehicle has been shut
down and the oil level has had time to stabilize.
Summary of Contents for VR70
