Depósito legal y copyright. Todos los derechos reservados.
11
PRO LIFTS S.L.
Quick operation guide
ENGLISH
5.2 -
The lift is supplied from the factory
completely greased. However, it is recom-
mended to periodically grease according
to use, the gearing, the axis bearings, the
spiral of the crank, and the sections.
5.3 -
All lifts should undergo an annual te-
chnical inspection carried out by an autho-
rized VMB dealer to check the certifications
and general condition of all the
lift’s elements and security systems invol-
ved in the lift’s use.
5.4 -
Only use original spare parts to gua-
rantee a continued security level. The user
loses all rights to warranty if any spare
parts other than originals are used or ca-
rries out any modification or alteration to
the towerlift.
5.5 -
To request a spare part please indi-
cate the corresponding code which can be
found in this manual together with the lift’s
serial number and year of manufacture.
6. GUARANTEE.
The warranty period for this lift is 2 years
from the date of purchase.
PRO LIFTS S.L. promises, that from the
date of purchase and during the warranty
period to resolve any faults that may occur,
produced through defect material or fabri-
cation. Damage caused by improper use,
product modification, third party manipula
-
tion or accidental fire are not covered by
this warranty.
If you release your finger from the ALS lock
it will automatically block. In this case, re-
peat the first operation by turning slightly
clockwise (
N
1
) and then anti-clockwise (
N
2
)
whilst always pulling the red ALS lock out. It
is necessary to completely lower each profi
-
le before starting to lower the next.
CAUTION:
THERE IS NO NEED TO PULL
THE ALS LOCKS HARD.
They unlock with the minimum pressure. If
you find it difficult to extract, please, turn the
winch clockwise slightly so that the pin is not
holding all the weight, If you pull too hard
you could damage or even break the ALS.
4.10 - Transport:
For the transport of the tower is necessary
to fold the machine lowering every profile
completely. Once the towerlift is completely
folded, place the legs in their transport com-
partment (
S
) and tighten the legs with the
security knobs (
K
), then the lift will be ready
to be transported.
5. MAINTENANCE.
5.1 -
Regularly check the state of the ca-
ble. If the cable has broken threads, or if it
shows any signs of crushed/flattened areas,
it should be changed and replaced immedia-
tely with a new one. Do not use the lift if the
cables are in bad condition. Only use VMB
steel cables reference: DIN 3060 torsion re-
sistant.
