3.3.- CONNECTION
The
DREC-C
must be connected to an installation protected with fuses suitable for its power
supply range and consumption.
Note:
Cross-section of the cable: 16 - 25mm
2
Terminals, opening covers or removing elements can expose parts that are
hazardous to the touch while the device is powered
If the
DREC-C
indicates a permanent failure (
AUTO
and
REC
LEDs are lit),
you must check the RCCB and the installation.
If the installation of the device is done with the RCCB in the OFF state, when
panel receives voltage the device will not activate the automatic reclosing sys-
tem for safety reasons And the
AUTO
and
REC
LEDs turn on to turn off in a
few seconds. A manual reclosing of the system must be done on the panel with
voltage.
3�3�1�- CONNECTION DIAGRAM 2-POLE MODEL: DREC-C-2P
F
N
CARGA / LOAD
Figure 1: Connection diagram DREC-C-2P�
8
DREC-C
Instruction Manual