This is normal and indicates that the instrument is
receiving electrical power.
To prevent this, turn off the mobile phone or use it further
away from the instrument.
The instrument is polyphonic up to a maximum of 64
notes including Dual voice, Split Voice, auto
accompaniment,song, and Metronome.Notes exceeding
this limit will not sound.
Make sure that the Auto Accomp Volume Function is set
to an appropriate level.
Is the Split Point set to an appropriate key for the chords
you are playing? Set the Split Point to an appropriate
position on the keyboard.
Is the chord indicator showing in the LCD display? If it
is not showing, press the CHORD button so that it does
show.
Check that the master volume control is not set to minimum.
Check that nothing is plugged into the headphone socket.
This is normal. The digital tone generation uses multiple
recordings(samples) of an instrument across the range of
the keyboard; The actual sound of the voice may be
slightly different from note to note.
The batteries are low or dead. Replace all six batteries
with completely new ones, or use the supplied AC
adaptor.
If you have lost or damaged your AC adaptor, please
contact your nearest store for a correct replacement
adaptor.
An incorrect AC mains adaptor which is not rated
sufficiently can cause malfunction or damage.
Perform a factory reset,Please refer to content in this
owner's manual.All of the user setting will be erased
and the default factory settings will be applied to the
instrument.
When the instrument is turned on or off, a Popping
sound is temporarily produced.
When using a mobile phone, noise is produced. Using a
mobile phone in close proximity to the instrument may
produce interference.
Not all of the voices seem to sound, or the sound seems
to cut off
The Auto Accompaniment does not sound properly
No sound produced by the keyboard, but the lights and
screen work.
The sound of the voice changes from note to note.
The volume is too soft.
The sound quality is poor.
The rhythm stops unexpectedly or will not play.
The recorded data of the song, etc. does not play
correctly.
The LCD display suddenly goes dark, and all panel
settings are reset.
To completely restore all settings as per factory settings
The sustain pedal or footswitch seems to produce the
opposite effect. Example pressing the footswitch
deactivates the sustain, and releasing the footswitch
triggers the sustain.
The polarity of the footswitch needs to be correctly
detected.Make sure the jack plug for the footswitch is
connected. Switch the instrument on whilst not touching
the pedal.
Troubleshooting Hints
23
