Se atIng and Securement
12
Removing the Front Passenger Seat
1. Turn the vehicle ignition OFF.
2. Move the seat into full forward position
to keep it from tipping backwards.
3. Disconnect seat wiring. Turn the outer
ring of the cable connector counter-
clockwise, and pull the cable out of the
connector. Place the end of cable in the
seat pocket or out of the way.
WARNING
Make sure ignition is OFF before
disconnecting the harness.
5. Release the seat base release strap and
lower the rear of the seat base to the
floor of the vehicle. The rear seat base
wheels will automatically lower so that
the seat and base can be easily rolled
out of the vehicle.
6. Pull the seat out of the front securement
brackets and remove seat from vehicle.
Installing the Front Passenger Seat
The installation procedure is the reverse
of the removal procedure.
1. Position the seat by rolling the seat
forward over the seat anchors in the
floor with the front seat base hooks
aligned with the front securement
brackets.
4. Pull the seat base release strap OUT.
While holding the seat base release
strap OUT, lift up the rear of the seat
and pull it backwards.
WARNING
Make sure the seat is in the
forward position before removal
or it may fall backwards.
2. Push the seat forward until the front
seat base hooks engage with the front
securement brackets.
3. Align rear seat latches over rear
securement brackets.
Summary of Contents for Northstar E Manual Conversion
