Se atIng and Securement
20
WARNING
If the belts do not restrain the
body properly, the wheelchair
must not be occupied during
operation of the vehicle.
Consult your mobility dealer if
additional securement measures
are necessary to ensure the
wheelchair and occupant are
secure.
Lap and Shoulder Belts
To secure an occupant in a wheelchair
use the OEM seat belt in conjunction
with the supplied lap belt extension.
Clip the lap belt extension to the floor
of the vehicle behind the wheelchair as
shown in
Figure 8
on page 17. Insert the
OEM seat belt tongue into the lap belt
extension receptacle. When using the
lap belt extension, do not route any belt
over the side panel or the armrest of the
wheelchair. The occupant must wear seat
belts against the body and low across the
front pelvis with the junction between the
lap and shoulder belts located near the
occupant’s hips as shown in
Figure 9.
Adjust the extension at the adjuster
buckle. The lap and shoulder belts must
not be held away from the body by the
wheelchair or any of its components.
Adjust the belts firmly, consistent with
user comfort. Use the vehicle belt height
adjustor if necessary. The belts must not
be twisted.
Figure 9
If the supplied lap and shoulder belts
cannot secure the wheelchair occupant
according to the instructions in this
manual, contact your mobility dealer for
other options.
Summary of Contents for Northstar E Manual Conversion
