VoCALL Compact User Guide & Log Book
Operation
All conversations on the VoCALL Compact system are under the command of the control handset,
Pt9 envisages the majority of calls to be made by lifting the handset of an outstation (type A) or pressing
the call button (type B).
Receiving a Call:
Lift the receiver; press the Zone key where the green LED is flashing. When connected the green LED
will go steady and the outstation will be connected to the handset.
To end Hang-up receiver or press the Zone key again to place the outstation on HOLD (the zone led will
flash slowly when held).
Making a Call:
Lift the receiver; press the Zone key for the required outstation, the green LED on the zone key will
flash. When the outstation answers the call the green zone LED will go steady and the handset will
connect to the called outstation.
To end the call, Hang-up receiver or press the Zone key again to place the outstation on HOLD (the
zone led will flash slowly when held).
Conference Call:
Up-to five calls can be conference called, by answering the calls or dialling the calls as described above
the master handset must be involved in the call and only one conference group is allowed.
Accepting Faults:
Note the fault in the log book, then Press the Mute Buzzer key this will silence the “waterfall” tone, while
the fault exists the fault buzzer will “beep” once every 15 seconds until the fault is rectified. The buzzer
will resound on each new fault.
Panel Test:
Press and hold the Mute Buzzer key for 5 seconds, the fault Buzzer will sound and all status LEDs will
Light.
Document DCC VCC7002-01 Rev 0 September 2008
Page 3 of 12
