Do not overreach. Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
Components:
OPERATION:
Assemble the extension handle
Slide the extension tube into the device as far as possible; until it clicks into place
(there is only one way to do this). Slide the other end of the extension tube into the
handle until the small catch pushes through the small hole. Check that both ends of
the tube are immovably in place. Press the ‘extension tube lock button’ or the ‘handle
lock button’ and pull the tube out of the device and the handle.
To install the nozzle:
The nozzle(8) can easily be pushed over the hot air nozzle.(4)
The protrud
ing points of the ‘weed burner’ nozzle must be pushed fully into the
slots of the burner nozzle.
The nozzle must then be twisted approximately one centimeter into the slot.
Attention!
The long side of the cap must be
on top
(this is the side where the switch is
located)
Never touch the nozzles during or immediately after use of the device. The nozzles are
very hot.
Temperature settings:
With the on/off- and power switch you can select from two temperature settings.
