Depending on the application, you can use the following settings:
Setting I 60 °C (venting / cooling)
Setting II 650 °C (weed burning) the volume of air in each setting 500 l/minute
Always use with caution! Do NOT cover the ventilation openings during use as it
causes a risk of burns! Never touch the hot nozzle!
Start to use
Check that all of the relevant safety measures have been implemented.
Ensure the extension handle is firmly fixed onto the device and that the device is
turned off.
Lead the electrical cable away from the burner nozzle through the cable clamps on
the extension tube and handle.
Install the nozzle to destroy weeds.
Insert the plug into the socket and turn it on.
Check to ensure the nozzles and air vents are not blocked before turning the device
on.
Slide the on/off and power switch to
Setting II
: the device will start to warm up.
Allow the device about 45 seconds to warm up to full heating capacity.
To eliminate weeds, hold the nozzle over the weeds for around 5 seconds. During
these 5 seconds the cell structure of the weed is destroyed. As a result, the weed
dies within a few days.
It is not necessary to completely burn the weeds, 5 seconds is more than sufficient.
For an efficient treatment the nozzle should be held around 0 to 5 cm above the
weeds.
The effects are not visible immediately but will take a while before they can be seen.
It is more of a long-term effect.
Cooling and permanent switching off:
Before turning off the device permanently, it must be cooled first.
Select temperature
Setting I
and operate for at least one minute. Allowing the
machine to cool down.
Once cool the Weed burner can be switched off.
During cooling down the appliance can be placed on its stand to allow it to cool
down
before storage.
Never leave the appliance unattended until completely cool.
Do not use your hand other body parts to check the temperature of the nozzles.
