11
Names and functions Continued...
10.
PITCH SLIDER
Use the slider to adjust the CD pitch. Slide up to decrease the pitch or down to increase the pitch.
11.
OPEN/CLOSE
Press it to open and close the disc tray. The main unit also includes OPEN/CLOSE buttons. The disc tray
cannot be opened during playback, so stop playback before pressing the button.
12.
LOOP
Press the LOOP button to set the loop start point, press the LOOP button again to set the loop end point.
Refer to page 13 for instructions on creating a loop
13.
KEY CONTROL
You can adjust source music in half-step increments, up to12 steps + (#) or - (b) from the original; or
“Natural” ( ) key. Push the
#
button to raise the key, and the
b
to lower the key. Use the button to return
to the original musical key. Each deck has independent KEY CONTROL, meaning that the separate outputs
can be adjusted individually, and even simultaneously if necessary.
14.
TRACK NUMBER PROGRAM
The numerical buttons are for quickly advancing to the track on a CD. Simply enter the number of the track
to jump to that track.
15.
PITCH
Use these buttons to enable or disable BPM adjustment with the pitch sliders. BPM adjustment with the
pitch sliders is enabled when the PITCH LED lights. You can switch between displaying pitch or key control by
holding the pitch button down for more than 0.5 second.
16.
PITCH +/–
The CD slows down, lowering the pitch while the (-) button is pressed. Release the button
to return to the original BPM. The CD speeds up, raising the pitch while the (-) button is pressed. Release
the button to return to the original BPM.
17.
REMOTE
CONTROLLER JACK
Connect this jack to the REMOTE CONTROLLER jack on the Player Unit using the included Control Cord.
18
11
12
15
14
16
10
13
CONNECT
TO
MAIN UNIT
17
Front Panel
Rear Panel
