20
Removing Modules
1. Unscrew the two retaining screws.
2. To remove, simply slide the module out of the compartment.
3. Align the cover plate, and tighten screws.
Antenna Installation
Insert the antenna’s TNC connector into the corresponding channel’s TNC antenna jack and twist clockwise until it is firmly
connected. If installing multiple antennas, ensure the antennas are not touching each other.
Microphone Battery Installation
1. To remove the lid, press down on the tab and slide the lid down towards the bottom of the microphone.
2. Insert 2 fresh 1.5-volt AA alkaline batteries. Make sure the batteries are inserted in the right direction according to
polarity (+/-)
Basic Operations
1. Press the POWER switch on the front panel of the STAGE-MAN.
2. Adjust the module level controls to approximately 50%.
3. Switch the microphone’s power switch to the ON position.
4. Talk or sing into the microphones and adjust the channel strip level and EQ controls (top panel) until you are satisfied with
the sound .
NOTE: During normal operation, the RF/AF signal LED’s will illuminate when a microphone is being used.
Antenna
Connector
Operations
