PFW 6875
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
www.vogels.com | Europe +31 (0)40 26 47 400
Attaching the Mount Bracket to the Flat-Panel
Mounting bracket adjustments are factory pre-set (see
Note
).
This section requires two people.
Do not release your flat-panel until you are certain that top and
bottom hooks of both mounting brackets are securely seated
on the upper and lower mounting rails of the wall panel.
1)
Raise the flat-panel past the top and bottom mounting rails on the
wall panel.
2)
Slide the flat-panel down slowly, keeping it close to the wall.
3)
Engage the top and bottom mounting brackets to the rails of the
mount.
Note:
These registers must
align prior to installation.
They are factory set.
Check to determine proper
alignment
Attaching the Flat-Panel to the Mount
Page 9
1)
Place your flat-panel screen-side down on a soft, flat surface.
2)
Identify the number and location of the thread inserts on the back of your
flat-panel.
3)
Aligning the holes on each mounting bracket with the thread inserts on the
back of your flat-panel.
4)
Secure each mounting bracket to your flat-panel by inserting a minimum of
two (2) screws per bracket.
Do not overtighten the mounting hardware.
