VGZ-005 / 20120202.0
BX42E-SN /
Page 5
ASSEMBLY INSTRUCTIONS
tools
required
CAUTION: STOVE IS HEAVY. MAKE SURE YOU
HAVE ADEQUATE HELP AND USE PROPER
LIFTING TECHNIQUES WHENEVER MOVING
STOVE.
Refer to diagram and parts lists at back of this manual.
1. Uncrate the stove and remove all packing materials
and protective poly bag. (Save exterior cardboard
for further assembly.)
2. Remove par ts from inside of stove. Par ts
include: two lids (#9), one lid support (#10) one
damper collar (#12), one feed door (#6), one lid lifter
(#14), four legs (#1), and S-Hook (#16) from inside
the firebox.
materials
required
(NOTE: The following items are NOT included with your stove)
6. Carefully lift stove upright and place in desired loca-
tion (see following instructions for properly locating
stove).
1/8” dia. Drill Bit
(sheet metal screws)
Screwdrivers
(blade and Phillips types)
5/16” Nut Driver or Ratchet
with 5/16” Socket (for 1/4”
Hex Nuts)
11mm Nut Driver or
Ratchet with 11mm Socket
(for Stove Bolts)
Safety Glasses
Hearth Gloves
Pencil
6 foot Folding Rule or
Tape Measure
Tin Snips
Drill: Hand or Electric
Flooring Protection: 52” x 74”
as specified (see page 3)
Chimney Connection: 6” black
steel (24 ga. min.) straight or
elbow (as required)
1/2” Sheet Metal Screws
Chimney: Existing 6” Lined Ma-
sonry Chimney or 6” Inside Dia.
listed Type HT chimney.
Furnace Cement (manufacturer
recommends Rutland Code 78
or equivalent)
NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or maintenance
of your wood stove and assumes no responsibility of any incidental or consequential damages.
Figure 1 – Hardware Pack
Figure 2 – Hearth Plate
Assembly
Figure 3 – Leg Assembly
3. Place flattened carton on floor and carefully turn
stove over onto carton.
4. Attach hearth to bottom of stove, figure 2, with two
short stove bolts (A), washers (E), and hex nuts (F).
5. The leg bolts (B)
pass through the
clearance holes
in the base of the
stove, figure 3,
through the legs
and then are se-
cured with flat
washers (E) and
hex nuts (F).
7. Attach damper collar to rear top surface of stove,
figure 4, using short stove bolts (A) flat washers (E)
and hex nuts (F).
Figure 4 – Damper Collar
9. Place lid support and two lids in position on swing
top.
10. Lower feed door into position while aligning hinge
pins.
11. Place S-Hook in hole at left front corner of hearth.
NOTE: S-Hook is used to hang lid lifter while not in
use.
Call us at 1-866-667-8454
NorthlineExpress.com
www.NorthlineExpress.com
