Vogelzang International VG7100, Installation & Operator'S Manual

9

FIREBOX BRICK REPLACEMENT

This furnace comes from the factory with the 

fi

 rebrick in-

stalled. However, if brick replacement is necessary, fol-
low these instructions. Before furnace operation, remove 
the brick retaining strip. This piece is used during ship-
ping to reduce brick damage.
There are 6 full brick and 1 half brick per side. Install the 
half brick 

fi

 rst by putting the bottom of the brick in 

fi

 rst 

and let it rest against the 

fi

 rebox side and 

fi

 re  grates. 

Then slide it to the rear. After that, install the  #2, #3, #4, 
#5 & #6 brick, sliding the 6th brick forward to allow for the 
7th brick. Repeat for opposite side.

NOTE:  Prior to operation, be sure to remove the brick 
retaining strips.

WIRING DIAGRAM

FIREBRICK AND BAFFLE REPLACEMENT

BAFFLE/BRICK REPLACEMENT

If baf

fl

 e replacement is necessary, slide the baf

fl

 e out un-

til you can access the nuts thru the 

fl

 ue outlet. Once the 

nuts have been removed, slide the baf

fl

 e off the rod and 

thru the opening in the 

fi

 rebrick. You may have to remove 

one of the 

fi

 rebrick to make baf

fl

 e removal easier.

There are 4 full brick and 1 half brick in the top of the 
furnace. Install the brick by inserting one end of the brick 
angled upward and then allowing the opposite end to rest 
on the 

fi

 rebox lip. Lay the brick between the spacer and 

fi

 rebox back. Slide the baf

fl

 e to the rear and let it rest on 

that half brick. After installing brick #2 in the front, install 
#3 and slide it under the baf

fl

 e.  Finally install bricks #4 

and #5.

All electrical connections should be done by 

a quali

fi

 ed electrician.

NOTE: The extra brown wire on the fan 

center has no use. It should be capped off or 

removed.

The conduit may be cut shorter to provide a 

cleaner installation.