Drill a 130mm diameter and four 3.5mm diameter hole as below picture.
Warning:
Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
ATTENTION
: If your cooker hood works at circulating-air mode, it is not necessary
to drill
130mm diameter hole.
Use the 4 screws to fix the cooker hood to a kitchen cupboard .Check that your fixings are
correctly located, by temporarily fitting the cooker hood. If correct, fit the unit into position.
Tighten the screws if necessary.
To mount on the wall, drill two10mm diameter holes 538mm with the vent hole on
the top of the cooker hood in the middle as below picture. Make sure the hood is aligned
directly over the hob.
Insert two plastics wall plugs(supplied) into the holes.
Insert two screws into the upper two plastic wall plugs and tighten them leaving 3mm
protruding from the wall.
Mount the cooker hood onto the two screws and mark the bottom two screw positions.
Remove the hood and drill the bottom two screw holes and Insert the plastic wall plugs.
Mount the hood on the top screws, Insert the bottom screws and fully tighten all the screws.
130
70
100
180
CUPBOARD MOUNTING INSTALLATION
WALL MOU NTING INSTALLATION
4
×Screws
（
ST5*49
）
4
×Screws
（
ST5*49
）
480
538
7
