8
Start Using Your Rangehood
Touch control with LED display
1. Press the “Power” button, the button control the “on” & “off ” of the hood.
2. Press the button “Speed” time after time, the motor runs as low / mid / high / low / mid…, the
speed runs circularly; and the LED display will indicate as 1-2-3-1-2… circularly.
3. Press “Light” button, the light is on, press this button again, the light is off. Please note the
Lamp is not under control of the on/off button.
4. When the hood is working, if press the “Timer” button, the hood will go into the status of
acquiescent working (acquiescent time is 9mins), and then, LED display will be shown
9.8.7.6 ...decreasing by 1,when time is up, the hood will be off automatically and the lamp
will extinguish. If pressing “Timer” button, the hood will go in or go out “Timer” function.
TROUBLESHOOTING
FAULT
POSSIBLE CAUSE
SOLUTION
Light on, but motor does not
work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not work, motor
does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or discon-
nected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet
are not tightly sealed
Take down the one way valve
and seal with sealant.
Leakage from the connection
of chimney and cover
Take chimney down and seal.
Lights not working
Broken/Faulty globes
Replace globes as per this
Insufficient suction
The distance between the
Rangehood and the gas top
is too far
Refit the Rangehood to the
correct distance.
The Rangehood inclines
The fixing screw not tight
enough
Tighten the hanging screw
and make it horizontal.
NOTE
: Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact the service centre if in any doubt before undertaking any of
the above. Always disconnect the unit from the power source when opening the unit.
