VOH SA
GU-04-06-01
PAViX - User Guide
Version 3.2
Created 10.2017
Page 33 / 48
6
Hand-setting
In order to have all the information required for traceability purposes, the user may be required to scan a certain
number of information before starting hand-setting operations.
6.1 User identification
When starting the PAViX, the user is prompted to identify from the home screen. Identification is carried out with
the bar code scanner.
Figure 51: Home screen without a scanner then in User or Expert mode with a connected scanner
The graph located above the “ON/OFF” icon (
) represents the memory used by the traceability data. The
graph is divided into 8 sections. Each section therefore equates to 12.5% of the total memory. When traceability
data occupies less than 12.5% of the total memory, the graph is empty (
). When the staking-tool is used and
the traceability data is stored, the graph gradually fills out. When the memory is full (
), the oldest data is
replaced by the newest data.
NOTE: Users can identify themselves as guests using the right-hand side button (
/
). In this case, user
traceability will be replaced by “GUEST”.
6.2 Selection of the hand-setting program
Starting a hand-setting program can be done two different ways.
-
Manual selection
-
Automatic selection by bar code (when the scanner is connected)
6.2.1 Manual selection
When manually selecting the corresponding program, the user uses the barrel and the buttons to perform the
selection.
PAViX screen
Comment(s)
After identifying himself/herself, the user
presses the right-hand side button (
) to
enable the manual selection of a program.
The family is then selected using the barrel
and validated with the right-hand side button.
The left-hand side button takes you back to the
previous page.
The program is then selected using the same
method.
