!
!
ATTENTION
Always load the correct preset for the loudspeaker before use.
Always be sure to connect the loudspeaker to the correct Speakon connector.
Otherwise the loudspeakers could be damage.
Upper Speakon connector for:
Amplifier channel 3 (OUT CH3, 800W) on Speakon 1+/1-
Amplifier channel 2 (OUT CH2, 800W) on Speakon 2+/2-
Bottom Speakon connector for:
Amplifier channel 1 (OUT CH1, 2400W) on Speakon 2+/2-
Amplifier channel 2 (OUT CH2, 800W) on Speakon 1+/1-
The amplifier channel 2, 800W is bridged on both sockets, so you can
use connect to the upper Speakon socket bi-amping tops if required,
which both need the 800W channel (e.g. CXN-16 in half-powered mode).
The powerful 2400W amplifier channel 1 is only connected to pin 2+/2-
on the the lower Speakon socket!
Connection HDSP-3 amplifier
