VOIspeed V-IP400 User Manual
©
VOI
SPEED
L
TD
.
7
NOTE:
before using the telephone you need to configure at least one user in the Pronto
server. In this way the telephone will be able to login.
3.4.
Getting Started
3.4.1.
Connection
•
Connect the LAN Ethernet port to the company switch/router/hub using an ethernet
UTP5 cable (not cross cable).
•
Connect the PC Ethernet port to a PC using an Ethernet UTP5 cable (not cross
cable) in case you need to.
•
Connect the power supply to the Power plug
This device is provided with ground connection. Use the device only in a fully earthed
electric system, with Residual Current Device (RCD) and relevant safety measures as
prescribed by law.
3.4.2.
Display
The V-IP400 telephone is provided with a backlit (green) LCD display. Please find below a
screenshot of the display with all segments being activated:
The table below lists all symbols meanings:
Icon
LCD Icon Definitions
Network Status Icon:
BLINK Network bind failure
ON, Ethernet link is up.
Network Status Icon:
ON, the phone uses a dynamic IP address
BLINK, the phone should work with dynamic IP address but no DHCP server found
OFF, the phone uses a static IP address
Network Status Icon:
ON, the phone uses a static IP address
BLINK, failure assigning the IP address
OFF, the phone uses dynamic IP address
Message Status Icon:
BLINK, new message on the vocal box
Missed call display
BLINK, missed calls not yet listened.
SIP1 (Public sip server) register Status:
BLINK Registration enabled but the registration procedure fails
ON the telephone is logged in
